| |
2pcs x BAOFENG UV5R 5W FM RADIO
FREE FOR: 1x SURECOM SW102 VHF/UHF mini Power & SWR Meter
Introduction:
BAOFENG UV-5R The transceiver is a micro-miniature Dual Band
FM transceiver with extensive receive frequency coverage,
providing local-area two-way amateur communications along with unmatched monitoring capability
Feature & Specification
VHF/ UHF DUAL-BAND TWO WAY RADIO
Frequency Range: 136-174 / 400-520MHz
Dual-Band Display, Dual Freq. Display, Dual-Standby
Output Power: 4 /1Watts
128 Channels
50 CTCSS and 104 CDCSS
Built-in VOX Function
1750Hz Brust Tone
FM Radio (65.0MHz-108.0MHz)
LED Flashlight
Large LCD Display
High/Low RF Power Switchable
25KHz/12.5KHz Switchable
Emergency Alert
Low Battery Alert
Battery Saver
Time-out Timer
Keypad Lock
Monitor Channel
Channel Step: 2.5/5/6.25/10/12.5/25KHz
ROGER SET
BAOFENG UV-5R Compare Products
| ■ Dual band, dual display, dual standby |
■ A/B band independent operation |
| ■ 128 groups channels storage |
■ Shortcut menu operation mode |
| ■ VFO & Memory channels scan |
■ Emergency Alarm |
| ■ background light selectable |
■ 0~9 grades VOX selectable |
| ■ PTT & ANI ID |
■ FM radio |
| ■ Voice companding |
■ 50 CTCSS/104 DCS |
| ■ |
■ PC programmable |
| ■ Wide/Narrow Band(25kHz/12.5kHz) |
■ Transmitter time-out timer(TOT) |
| ■ High/Low TX power selectable |
■ Busy channel lock-out(BCLO) |
| |
|
Specifications:
| Item number |
UV-5R |
| General |
| Frequency Range |
65-108MHz(FM Receive only) |
| 136-174MHZ and 400-520MHZ (TX/RX) |
| Channel No. |
128 |
| Frequency Stability |
±2.5ppm |
| Antenna |
High gain Dual Band antenna |
| Antenna Impedance |
50Ω |
| Operating Voltage |
DC 7.4V |
| Mode of operation |
Simple or semi-duplex |
| Dimension（W x H x D） |
100 x 52 x 32 mm |
| Weight |
250g（including battery, antenna） |
| Transmitter |
| Output power |
4W / 1W (Max 5W) |
| Modulation Mode |
16kΦF3E / 11kΦF3E |
| Maximum deviation |
＜5kHz(Wide) / ＜2.5kHz(Narrow) |
| Spurious Radiation |
＜7μW |
| Adjacent Ch. power |
≤-65dB(Wide) / ≤-60dB(Narrow) |
| Pre-emphasis characteristics |
6dB |
| Current |
≤1.6A(5W) |
| CTCSS/DCS deviation |
0.5±0.1kHz(Wide) / 0.3±0.1kHz(Narrow) |
| Inter mediation sensitivity |
8-12mv |
| Inter mediation distortion |
＜10% |
Package Contents
2 x UV-5R (136-174 / 400-520MHz)
2 x 7.4V 1800mah Li-ion Battery Pack
2 x Antenna
2 x Belt Clip
2 x ENG Manual
2 x Desktop Charger ( 100V ~ 240V )+(2pin USA or 3pin UK or 2pin EURO or 2pin Australia)
- Package Contents
- 1x SURECOM SW-102-UV Power & SWR Meter (N - connector)
- 1x Power PSU 100-240V
- 1x Charger Cable
- 1x English Users Manual
- 2x adaptor for UV-5R
The first from ,
V3.3,V3.8,V4.3, V4.5,V5.1 ,V2.02,V2.03 new
V2.02 , V2.03 is new version , the watt refenece is best than V3.3,V3.8,V4.3, V4.5,V5.1 .
**All Specifications are subject to change without notice
OPTIONAL :
N to SO239 connect adaptor
N to SMA connect adaptor
N to BNC connect adaptor
DUMMY Load
Do not affect the test in the following cases, there are objects nearby, placed horizontally.
Note: Damage your radio when Connect without Antenna and Dummy.
| SURECOM SW-102 Q & A |
| 1. |
- PLease charge with USB cable +5V , or come with PSU .
- Push and hold on the "RED" botton .
- Replacement battery when battery dead. (below Ver 5.1 use by 14500battery,V1.X use by li-ion polymer battery.
- There are still problems with steps 1. and 2.and 3., please contact service center.
|
| 2. |
- Watt /SWR read data is not hold on ?
- Some Radio problem when end of TX
- .Radio output TX is not stabilizing.
|
| 3. |
- Read the watt data is not accurate ?
- SW-102 is not for DMR system
- Don't not use the antenna get the watt data.
- Please use the correct power dummy load to measure (must be 50 OHM)
- The data read error when not read the frequency from radio
- The TX input is weak
- Input Watt below 0.5W
|
| 4. |
- Read the S.W.R. data is not accurate?
- SW-102 is not for DMR system
- Do not affect the test in the following cases, there are objects nearby
- Do not affect the test in the following cases,placed horizontally.
|
| 5. |
- Read the Frequency counter is not display or read frequency not accurate?
e.g. Radio is 145.000 , read 145.003
- SW-102 is not for DMR system
- Input below 0.5W
- Please use menu mode and fine tune the frequency offset.
|
| 6. |
- Display have problem ? e.g.BLack or Garbled or no Display
- Restart the SW-102
- Remove the inside battery.
- There are still problems with steps 1. and 2., please contact service center.
|
| 7. |
- How to RESET the mirco chip
- Off mode ,
- Hold the Red button when the display show "restore to default "
- There are still problems with steps 1. and 2., please remove the battery.
|
| **All Specifications are subject to change without notice |
|
Free Upgrade Version Service
- Customers who bought the old version (Below V4.5) SURECOM SW102-VU Meter can get a FREE UPGRADE now!!!
- Customers only need to:
- Send back Parts of the SW102-VU (like Pic 1) to us . (whitout battery and cover)
- Afford the Send back to Hong Kong shipping cost
- Include Return shipping address in package
- After we received your send back SW102-VU, will help you upgrading into V5.1 and then send back to you without any cost.
Don't miss the chance!!!
 
Pic.1
|
|
